HP 40G User Manual page 203

Downloaded from www.Manualslib.com
To label parts of a
sketch
To create a set of
sketches
To store into a
graphics variable
Notes and sketches
manuals search engine
1. Press and type the text in the edit line. To lock the
U@YU•
Alpha shift on, press (for uppercase) or
6a•
(for lowercase).
To make the label a smaller character size, turn off
before pressing . ( is a toggle between small and
6a• 7DB•
large font size). The smaller character size cannot display
lowercase letters.
2. Press .
PF•
3. Position the label where you want it by pressing the
, , keys.
4. Press again to affix the label.
PF•
5. Press to continue
9S6X•
drawing, or press
to exit Sketch
view.
You can create a set of up to ten sketches. This allows for
simple animation.
• After making a sketch, press
I@XQ•
page. You can now make a new sketch, which becomes
part of the current set of sketches.
• To view the next sketch in an existing set, press
Hold down for animation.
Q6B@É•
• To remove the current page in the current sketch series,
press .
You can define a portion of a sketch inside a box, and then
store that graphic into a graphics variable.
1. In the Sketch view, display the sketch you want to copy
(store into a variable).
2. Press .
TUPc•
3. Highlight the variable name you want to use and press
.
PF•
4. Draw a box around the portion you want to copy: move
the cursor to one corner, press
to the opposite corner and press
6a•
7DB•
,
to add a new, blank
.
Q6B@É•
, then move the cursor
PF•
.
PF•
14-5