Replacing The Battery; Troubleshooting - CEN-TECH 96308 Owner's Manual

1. When the Low Battery symbol
low and must be replaced.
2. Remove the screw on the Battery Compartment, and replace the batteries with (3)
new batteries of the same type (3VDC CR2032). Be sure all three batteries have the
"+" side facing upward. Incorrect battery polarity will prevent proper operation of the
meter. NOTE: You may have to move the clip to access the Battery Compartment.
Problem
Tool will not start
Erratic or incorrect
readings
Item 96308

Replacing the Battery

TROUBLESHOOTING

Possible Causes
1. Batteries worn out.
2. Incorrect battery polarity
1. Loose or damaged Test Leads.
2. Poor connection or corroded parts.
For technical questions, please call 1-888-866-5797.
is shown on the Display Screen, the batteries are
Probable Solutions
1. Replace batteries
2. Ensure that all batteries have
"+" facing upward in Battery
Compartment.
1. Check condition on Test Leads.
2. Check condition of part and clean if
necessary.
Page 11