troubleshooting
Problem: the Frisper sounds like it is working but.....
nothing is happening.
Are you trying to Frisp from a used spot on the bag?
•
Open the Frisper and move the bag to a fresh spot to frisp.
Are you overlapping or too close to a used spot?
•
If so, move the bag away from the used spot by
1/4-inch and try again.
Is the vac-snap zipper fully closed?
•
Re-zip again using the zip-disc.
Are the foods in the bag fatty or juicy?
•
With a clean dry paper towel, wipe down the zipper treads on the
inside of the bag.
Is food bunched up and under the Frisper lid?
•
Remove bag from Frisper, shake food to opposite side and re-frisp
the circle you have already started. Make sure you line the puncture
tooth up and directly over the puncture you just made.
Is the drip tray full?
•
Empty, rinse out and thoroughly dry.
Is the heat-sealed circle complete and is the thickness of the seal even?
and through?
•
Visually review the heat seal impression left on the bag. If the seal
is not even and through, line up the puncture tooth over the hole it
made and re-frisp.
Is the flexi tube plugged into the Frisper's flexi tube valve port?
•
Remove flexi tube and re-frisp.
Did you firmly press down on the lid? or just tap it?
•
Open lid, make sure puncture tooth is aligned. Press firmly down on
the lid and let go.
Is the vac-snap zipper bag edge lined up along the drip tray marking
line? Is the vac-snap zipper bag overlapping the inside of the Frisper
and bunched up under the lid?
•
Open the lid, move the bag edge to run parallel to the drip tray edge
with the zipper facing right or left.
10
Problem: Frisper is not working and there is no sound
when i press down on the lid.
Is the electrical cord plugged into a 120 V AC outlet?
•
Plug the Frisper into a wall outlet.
Is the terminal connector of the adaptor plugged into
the Frisper?
•
Plug adaptor into the rear terminal of the Frisper.
Is the correct AC adaptor used?
•
Check the adaptor to make sure it's the Frisper's.
Is the LED indicator light off?
•
Check the above 2 steps
Is the lid closed down firmly?
•
You will hear a 'click.'
Problem: Bag and food are wet.
•
Always par freeze liquids first before frisping.
•
Pat meats or vegetables dry before frisping. Use a
paper towel as a blotter inside the vac-snap zipper bag
— it becomes a wick and helps to seal moist foods.
Problem: Bag is leaking air.
Is the heat sealed circle complete? Is there a tiny puncture
somewhere on the vac-snap zipper bag?
•
Visually inspect the vac-snap bag. Check the heat seal
impression left on the bag.
•
Re-frisp if necessary.
Is the zipper closed completely?
•
Re-zip again using the zip-disc.
Are you using a Frisper vac-snap zipper bag?
•
Zipper bags from the grocery store aren't made
strongly enough, and air passes through them.