Description Of Warning Marks On The Front Panel - Beha-Amprobe GT-650 User Manual

GT-650/GT-900 User's Manual

Description of warning marks on the front panel

Figure 1: Explanation of safety and
measurement category (CAT) rating of
input / output terminals
Warning 4:
230 V CAT II is max. allowed voltage between PROBE 2 and earth
Touch Leakage Current (I
from mains socket of GT-650/GT-900 tester and it is allowed only to connect PROBE
2 to touchable parts of the DUT.
100 V is max. allowed voltage between PROBE 2 and earth
Extra Low Voltage (PELV) and Safety Extra Low Voltage (SELV).
Do not apply any external voltage to PROBE 2 in any other function.
100 V max. is allowed voltage between PROBE 1 and PROBE 2.
Warning 5:
Use this socket for test purpose only!
Do not feed in any external voltage (touchable conductive parts of the tester may
not be earthed, if GT-650/GT-900 is not powered with mains)!
This socket is allowed to be supplied from GT-650/GT-900 test / mains socket
(schuko socket) only while performing measurements on CORD or PRCD (while
performing the measurements GT-650/GT-900 is powered with mains supply and
touchable conductive parts of the tester are earthed in this case)!
). While this measurement the DUT must be powered
T
11
Warning 1:
Use this test socket for CLAMP
connection only! Use the clamp listed
in chapter "Scope of Supply" on
page 8 only!
Input: Max. 60 mA / max. 0.5 V!
Note! One terminal is earthed!
Warning 2:
Use this test / mains socket for test
purpose only!
Output: CAT II 300 V !
I , I and POWER measurements:
PE T
Intermittent use!
Max. 4 minutes measurement
duration / 3 minutes pause!
Warning 3:
100 V is max. allowed voltage
between PROBE 1 and earth !
100 V is max. allowed voltage
between PROBE 1 and PROBE 2.
R measurement: Intermittent use!
PE 5A
Max. 2 minutes measurement
duration / 3 minutes pause!
in functions Protective
in function