Onkyo HT-S5200 Quick Setup page 2

AV Component Hookup
If you have an HDMI-compatible TV and players, you can connect them
to the AV receiver with HDMI cables. The audio and video signals received
via the HDMI inputs are output by the HDMI OUT as they are (pass-through).
To listen through the speakers connected to the AV receiver, please make
the audio connections shown below.
L
Cable/
R
COAXIAL
HDMI
OUT satellite
AUDIO Antenna input
DIGITAL
OUT OUT
Assigning the Digital Input
If there's no sound, you'll need to assign the
digital inputs as necessary using the setup
menus on the AV Receiver's display.
If you connect your DVD/BD player to the AV
receiver's DIGITAL IN COAXIAL 1, and your
cable/satellite receiver to the DIGITAL IN
COAXIAL 2, as shown, it's not necessary to
assign the digital input.
HDMI
IN
To fully enjoy the AV receiver's
listening modes, turn off the
volume on your TV.
L
DVD/BD
R
COAXIAL
HDMI
OUT player
AUDIO
DIGITAL
OUT OUT
Coaxial feed from TV antenna
If you are not using Cable/satellite box,
(e.g., RF IN)
please refer to the instruction manual.
On the front panel
IF NO HDMI
DIGITAL AUDIO VIDEO
OUT OUT
COAXIAL L
R
TV
COAXIAL
DIGITAL
OUT
Connecting a supplied UP-A1L with the Port connector
See the other side of this sheet for the Speaker hookup. See the other side of this sheet for the Speaker hookup.
If your TV or player doesn't support HDMI, use the analog or digital
connections shown below.
DVD/BD
OUT
player
Please ensure the monitor input
(VIDEO 1, VIDEO 2, VIDEO 3, etc.)
selected corresponds to actual
connection used.
L
Cable/
R
satellite
VIDEO AUDIO Antenna input
OUT OUT (e.g..RF IN)
TV
VIDEO 1
IN
Coaxial feed from
TV antenna
If you are not using
Cable/satellite box,
please refer to the
instruction manual.