Table of Contents
Advertisement
Method B: Software Control through RS-232 port / Ethernet port
System Requirement and Precautions
1. Whenever power off MX-5004MZ, please stay unpowered at least 5 to 10 seconds to allow power
capacitors to discharge.
2. The MX-5004MZ provides software control program which runs under Microsoft Windows 98, 2000,
XP, 7, 8 through the interface of RS-232 serial control.
3. Before clicking on the icon of the software, make sure you have secured the connection between
your computer COM port and the MX-5004MZ.
Start the software control program
When clicking on the executable file, the following dialog will pop-up. There are two ways to control the
MX-5004MZ device (under Microsoft Windows 7, please run as administrator).
RS-232 serial Mode: Use RS-232 to connect the port on device and computer. Select correct COM port
and click the OK button.
Ethernet Mode: Enter the IP address of the device and click the OK button.
After the software control setting is accomplished, it will enter directly to control interface.
6
Advertisement
Table of Contents
