Current characterized errata are available on request. Contact your local Intel sales office or your distributor to obtain the latest specifications and before placing your product order.
Safety and Regulatory Notice ® See the Intel Desktop Boards D850EMD2 and D850EMV2 Product Guide for all applicable regulatory compliance statements, product certification markings, and safety and electromagnetic compatibility (EMC) standards and regulations these desktop boards are compliant with.
Desktop Board Components Line USB 2.0 Devices Power LED HD LED Reset No Connection Ground J8J1 OM13641 continued Intel Desktop Boards D850EMD2 and D850EMV2 Quick Reference...
Page 5
CAUTION Failure to use an ATX12V power supply, or not connecting the additional power supply lead to the Desktop Board D850EMD2 or D850EMV2 may result in damage to the desktop board. For more information on the ATX12V power supply, refer to the Intel Desktop Boards D850EMD2 and ®...
Serial Presence Detect (SPD) memory only • ECC and non-ECC support ✏ NOTE For information about vendors that support these memory requirements, refer to the D850EMD2 or D850EMV2 link on this Intel World Wide Web site: http://support.intel.com/support/motherboards/desktop Intel Desktop Boards D850EMD2 and D850EMV2 Quick Reference...
Refer to your chassis manual for specific instructions on installing and removing the desktop board from the chassis. The Desktop Board D850EMD2 is secured to the chassis with 11 screws and Desktop Board D850EMV2 with eight screws. Refer to the board illustration on page 4 for the location of the mounting holes.
Lower the lever back to its original position. OM12078 For instructions on how to install the processor fan heat sink, refer to the boxed processor manual or the Intel World Wide Web site at: http://support.intel.com/support/processors/pentium4/intnotes478.htm 4 Installing the Memory Modules...
5 Installing an AGP Card ✏ NOTE The desktop boards D850EMD2 and D850EMV2 are only compatible with 1.5 V AGP cards. The desktop boards D850EMD2 and D850EMV2 have an integrated AGP retention mechanism. Follow these instructions to install an AGP card: Place the AGP card in the AGP connector.
The following figure shows the location of the fan connectors. Connect the chassis fan cables to the desktop board connectors as shown in the figure below. ® The processor fan and fan 2 can be monitored via the Intel Active Monitor software application.
The BIOS configuration jumper block (J9H2) determines the operating mode of the BIOS Setup Program and enables BIOS recovery in the event of a failed BIOS update (see the previous figure for the location of the jumper block). Intel Desktop Boards D850EMD2 and D850EMV2 Quick Reference...
To disable the LAN interface, select the Peripheral Configuration Submenu under the Advanced Menu, then set LAN Device to “Disabled.” You can find a complete list of the latest BIOS Setup settings in the Intel Desktop Boards D850EMD2 and D850EMV2 Product Guide or on the Intel World Wide Web site at: http://support.intel.com/support/motherboards/desktop...
Need help?
Do you have a question about the D850EMD2 and is the answer not in the manual?
Questions and answers