Maintenance & Technical Data - Prime Design Baselight 420X User Manual

MAINTENANCE
Baselight is designed for minimal maintenance and use in remote locations. It is a key feature of
the product to require little or no maintenance. The recommended maintenance is as follows:
Before every usage the operator must:
Check electrical wires for damage.
This relates to:
-Main power cable & plug
-Extension cable & plug
-Armature cables
-Spiral cable
Any damaged found on these items re-
quire immediate service. Do not proceed
with operations until fault is removed.
TECHNICAL DATA
Wind resistance without ballast......................................Up to 20 m/s
Wind resistance with ballast................................................Up to 30 m/s
Luminous flux.................................................................50.000 Lumen
Light source lifetime.........................................................50.000 Hours
Working temperature................................................-30 to + 45 Deg C
Operating voltage.................................................90 to 305 VAC/50Hz
Power connector............................................................CEE or Schuko
Colour temperature...................................6000 Kelvin (Bright Daylight)
Power consumption...................................15 to 420 Watt (Dimmable)
IP Rating.........................................................................................IP67
Weight..................................................................................35Kg(77lb)
Fully extended height............................................ 4.7 Meters (16 feet)
Transport dimensions.............................................. 1200mm x 280mm
Certification................................................................................................CE
Every year:
Lubrication of the telescopic mast.
Each year the inside of the mast sections should be
lubricated with silicon spray. This is a simple proce-
dure that involves the following steps:
1. Lift each mast section (one at a time) while
holding out the red lock until part of the mast
locking hole is visible above the lock itself.
2. Spray silicon inside for about 3 seconds.
3. Release red lock and slide mast section down.
4. Repeat procedure for every mast section.
PAGE 10