Client Dot11B-Forbidden; Client Dot11N-Only - HPE FlexNetwork MSR Series Command Reference Manual

Parameters
20: Sets the bandwidth mode to 20 MHz.
40: Sets the bandwidth mode to 40 MHz.
Usage guidelines
This command is applicable only to 802.11n radios. When you change the mode of a radio, the
default setting of this command for the new radio mode is restored.
If the current channel of a radio does not support the specified bandwidth mode, the radio clears the
channel configuration and selects another channel.
If the bandwidth mode is set to 40 MHz, the radio uses the 40 MHz bandwidth if two adjacent
channels that can be bound together exist. If there are no adjacent channels that can be bound
together, the radio uses the 20 MHz bandwidth.
Examples
# Set the bandwidth mode to 40 MHz.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] channel band-width 40

client dot11b-forbidden

Use client dot11b-forbidden enable to disable access services for 802.11b clients.
Use client dot11b-forbidden disable to enable access services for 802.11b clients.
Use undo client dot11b-forbidden to restore the default.
Syntax
client dot11b-forbidden { disable | enable }
undo client dot11b-forbidden
Default
Access services for 802.11b clients are enabled.
Views
Radio interface view
Predefined user roles
network-admin
Usage guidelines
Enabling an 802.11g or 802.11gn radio to reject 802.11b clients reduces the impact of low-speed
802.11b clients and speeds up wireless data transmission.
Examples
# Configure WLAN-radio 1/0/2 to reject 802.11b clients.
<Sysname> system-view
[Sysname] interface wlan-radio 0/1
[Sysname-wlan-radio-0/1] client dot11b-forbidden enable

client dot11n-only

Use client dot11n-only enable to enable the client dot11n-only feature.
5