Ford Escape 2010 Workshop Manual page 34

4. Air pressure setting for applicator gun is 448-517 kPa (65-75 psi).
 Use the long wand when spraying enclosed areas. The spray nozzle provides a 360-degree
 The short, hook-shaped wand sprays in one direction and must be rotated to provide
 Apply the material in light mist coats.
 Material displaces moisture.
5. Clean up any overspray with a mild solvent such as mineral spirits or bug and tar remover.
NOTE: The following illustrations provide typical applications of body seams and spot welded flanges and are not
vehicle specific.
2. NOTE: Door assembly lower view.
Apply rust inhibitor as shown to the inside of the door shell on all the interior metal surfaces using the most
suitable applicator wand. Apply material to the exposed edges after carrying out the welding process. Make
sure horizontal surfaces are well protected as they are more susceptible to corrosion. Keep door drain
holes clear to prevent moisture buildup.
3. NOTE: Quarter panel inner view.
Apply rust inhibitor to the closed channel portion of the spot weld flange areas using the short, hook-shaped
wand. Apply material to the exposed edges after carrying out the welding process. Make sure horizontal
surfaces are well protected as they are more susceptible to corrosion.
spray pattern. Insert the wand as far as possible into the access hole, pull the trigger and
wait 2-3 seconds and slowly pull the wand out of the access hole.
complete coverage.