Storage - Bradco 617 Operator's Manual

M
GENERAL INFORMATION
The following storage procedures will help you to keep your trencher
in top condition. They will also help you get off to a good start the next
time your trencher is needed. We therefor strongly recommend that you
take the extra time to follow these procedures whenever your trencher will
not be used for an extended period of time.
PREPARATION FOR STORAGE
1 . Clean the trencher exterior thoroughly, removing all mud, dirt, and
grease.
2 . Tighten all loose bolts, nuts, and set screws.
3 . Touch up unpainted and exposed areas with paint to prevent rust.
4 . Coat the digging chain with a thin covering of oil. Operate chain for a
short period to work the oil into the pins.
5 . Store the trencher in a dry and protected place. Leaving the trencher
outside, exposed to the elements will materially shorten its life.
6 . Inspect trencher for visible signs of wear, breakage or damage. Order
any parts required and make necessary repairs to avoid delays when
starting next season.
7 . Replace operating decals if damaged or in unreadable condition.
REMOVING FROM STORAGE
1 . Remove all protective coverings
2 . Check hydraulic hoses for deterioration and if necessary, replace.
3 . During cold weather, operate the trencher slowly for a short time
before placing the unit under full load.

STORAGE

617 TRENCHER
M
5797
2-26-92