Mounting Instructions - Bradco 617 Operator's Manual

E
GENERAL INFORMATION
A mounting kit is required to attach the trencher to the skid steer.
Your trencher may have been shipped with the mounting kit installed. The
following instructions are provided here to help you install the mounting kit
in the case that yours was not installed at the factory.
This manual contains a diagram and parts list of the mounting kits
located in the front of this section. To determine which mounting kit you
need for your skid steer, refer to the chart in Section D. Study the diagram
and familiarize yourself with the names of the various parts. This knowl-
edge will assist you in understanding these instructions. Read the complete
mounting instructions that follow before you begin. Read all safety warn-
ings before operating the trencher.
In addition to the complete trencher assembly which includes the
mounting and hydraulic kit, you will also need a pair of couplers (one male
and one female) to hook-up the hydraulic hoses. The couplers must fit the
male hydraulic hose ends. The couplers must also mate up to the skid
steer's auxiliary hydraulic system couplers. You should be able to purchase
such couplers from your skid steer dealer.

MOUNTING INSTRUCTIONS

1 . Remove all shipping banding from the trencher and attaching
bracket(s). Remove any other mounting kit components from their
packaging.
2 . NOTE: The side shift mounting frame may have been shipped already
installed. In the event yours was not installed -attach the side shift
mounting frame to the trencher by sliding the two side shift inner
tubes (part #78824) through the trencher mount lining up one set of
side shift holes and installing the lock pin (part #79113). Attach the
side shift mounting frame to the side shift inner tubes using the four
.75"UNC x 4.50" capscrews and lock nuts provided. (See Figure #1)
MOUNTING KIT INSTALLATION
617 TRENCHER
E
5777
2-21-92