Remington 494 Operating Instructions Manual page 11

G 018
482-59
6. Power fasteners are a permanently installed fixture. An act of demolition is required for their
removal. Appropriate safety precautions must be taken.
Head
Shank
Plastic Flute
482-60
7. NEVER use common nails or other materials as fasteners. Remington Power Fasteners are
manufactured from special steel and heat treated to produce a very hard yet ductile fastener.
G 018
8. NEVER pry a power load out of the tool. Prying can discharge the load causing serious injury
(see Troubleshooting Guide , page 16).
9. ALWAYS insert the power fastener first, then the power load. If work is interrupted for any
reason, ALWAYS remove the power load before removing the power fastener (see page 15,
item 7).
101437
Safety Precautions
11