Pc Control Codes; Cable Connection - NEC PH2601QL Installation Manual

PH2601QL & PH3501QL Installation Guide
Desktop and Ceiling Mount

PC Control Codes

Function
POWER ON
POWER OFF
INPUT SELECT HDBaseT
INPUT SELECT HDMI
INPUT SELECT DisplayPort
INPUT SELECT SLOT
PICTURE MUTE ON
PICTURE MUTE OFF

Cable Connection

Communication Protocol:
38400 bps (for cable lengths longer than 20', it is recommended changing to 9600 bps in setup menu)
Baud Rate:
Data Length: 8 bits
Parity: No Parity
Stop Bit: One bit
X on/off: None
Communications: Full duplex
PC Control Connector (D-Sub 9P)
Note 1 : Pins 1, 4, 6, and 9 are used inside the projector.
Note 2: For long cable runs it is recommended to set communication speed within the projector to 9600 bps.
Note 3: Jumper "Request to Send" and "Clear to Send" together on both ends of the cable to simplify cable connection.
www.necdisplay.com
Code Data
02H 00H 00H 00H
02H 01H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 03H 00H 00H
02H 10H 00H 00H
02H 11H 00H 00H
PH2601QL/PH3501QL
NEC Display Solutions of America, Inc.
00H 02H
00H 03H
02H 01H 20H 28H
02H 01H A1H A9H
02H 01H A6H AEH
02H 01H ABH B3H
00H 12H
00H 13H
Rev 1.0
Page 11 of 11