HP Elite Slice for Meeting Rooms G2 Hardware Reference Manual page 20

TIP: When routing cables under a table or other surface, cable guides, shown in red above, should be used
to minimize stress on the cables.
1. Connect the Video Ingest Module (required) to the Elite Slice G2.
2. Connect additional modules, if desired, to the Elite Slice G2.
3. Place the Elite Slice G2 in a central location.
Be sure nothing is placed on top of or next to the Elite Slice G2 that could block speakers and
microphones.
4. Connect the Cable and Port Cover to the Elite Slice G2:
a. Pull the port cover down (1) to expose the cable connectors.
b. Pull the first and last connectors out to each side (2).
c. Beginning with the HDMI connector and finishing with the NIC connector, plug all middle connectors
into the rear ports (3) on the Elite Slice G2.
d. Connect the first and last connectors (4).
e. Push the port cover back over the cable connectors (5) to protect and secure the connectors.
5. Connect the CoRC.
a. Connect the USB-C cable from the top of the Cable and Port Cover to an exit port on the rear of the
CoRC (1). Press the cable into the channel (2) to exit on either the left or right side of the CoRC.
14 Chapter 2 Setup