Your BT Voyager 1040 Wireless Adaptor Guide
Do not plug in your BT Voyager Wireless Adapter until instructed to do so in this guide.
Windows 98 users may require their windows CD during installation – Please make sure the
Windows Installation disk is available before you continue.
Your Wireless Pack Contents:
1 x BT Voyager 1400 Wireless Router
1 x Quick Start Guide and CD
Software Installation
Before installing your PCI expansion card, you should install the driver software.
1
Insert the BT Voyager Wireless CD into your computer's CD-ROM drive. The CD will autoplay,
bringing up a menu screen from where you can start the installation process.
2
To install, click Install BT Voyager Wireless Adapter and click Next when the
installation wizard starts. You will be asked to read the Software License Agreement, you should
continue by clicking Yes.
3
Next you will be asked to confirm where to install the driver files, if you are happy with the
default directory, click Next.
4
When the driver files have finished copying, click Finish. You have now completed the software
installation phase.
Hardware Installation
You are now ready to fit the Voyager 1040 PCI Adapter into your computer.
5
Ensure that your PC has been shutdown, unplug the power cable or switch off power at
the mains socket.
6
Access your PC motherboard - refer to your computer manual or supplier if you are unsure how
to do this.
7
Once you have access to you PC motherboard, locate a free PCI slot. You will need to
remove the corresponding cover plate to provide an opening and fixing point for the Voyager
1040's endplate.
Important –
If you are installing this wireless adapter as part of an existing wireless
network with a base unit (e.g. BT Voyager 2100), you should install and
switch on the base unit before proceeding.
Instructions continue on other side