Advertisement
4.
STORAGE
3
- After cleaning, carefully store all of the cutting equipment in
the storage cupboard fi xed to the wall.
Fault fi nding
5.
THE MACHINE WILL NOT START, CHECK THAT :
1
• The machine is plugged in.
• The electrical power supply to the socket is correct.
5.
ABNORMAL NOISES :
2
• Stop the machine.
• Check that the rotating parts are fi tted correctly (disc, ejector).
• Dismantle, clean if necessary and refi t.
5.
WORK QUALITY
3
Before carrying out any work, stop the machine.
• If the products have not been cleared properly, check that :
- the ejector is fi tted correctly,
- the products in the receiving bowl are not blocking the outlet,
- there is not an accumulation of products in the cutting cham-
ber.
• If the quality of the cut is not satisfactory, check :
- The direction of rotation (anticlockwise
above)
Maintenance
Before dismantling any part, disconnect the appliance from the power supply.
Maintenance may only be carried out by a qualifi ed, trained and authorised person
6.
ADJUSTMENT OF THE SAFETY DEVICES
1
• Check that the safety devices are operating correctly before
each use. The motor should stop within less than 2 seconds.
- When the feed arm is lifted, the gap F should be 30 mm
maximum from the edge of the feed hopper.
- When the hopper assembly or the cutter cover is unlocked.
6.
ELECTRICAL COMPONENTS
2
6.
2
see electrical diagram
• Identifi cation of the colours of the wires :
• Access to electrical components.
- Unplug the machine.
Residual voltage at the capacitor terminals.
• The capacitors may retain an electrical charge. To avoid
taking any risks when carrying out work, we recommend dis-
charging them by connecting their terminals with an insulated
conductor (e.g. a screwdriver).
- Power circuit :
- Control circuit : red
- Motor
:
- Phase
:
- Neutral
:
MUG GB 06 07
4.
3
black
(G)
- (F) black- (A) red- (E) blue-
Orange
(H)
Violet
L
N
• The «fresh cut» equipment is locked in the correct position.
• The feed arm is in the feed hopper.
- The choice of disc used (see §3.2).
- The condition of the cutting equipment.
- The choice of the feed hopper.
- the way that the products are in the feed hopper (see §3.4).
If the problem persists, contact the service department
of your local dealer.
viewed from
ATTENTION !!
6.
1
• If either of the two safety devices does not work :
- Do not use the machine.
- Have it adjusted by the service department of your local
dealer.
- Earth
- Control cable : (J)
white
• Identifi cation of the components.
O
: Stop button
I
: Start button
S1
: Feed hopper assembly or bowl delete safety device
S5
: Feed arm safety device
B
: Terminal block
M
: Single phase motor
Kl
: Start-up relay
CP
: Permanent condenser
CD/F : Start-up - braking condenser
CPu
: Power board
X
: Power supply cable
6
:
B/C yellow-green .
Brown- (I) grey - (K) pink- (E) blue - (D)
Advertisement
