Anviz T50 Manual

Reader Appearance

74 mm
LCD
1 2 3 c/
4 5 6 0/
7 8 9 OK/M
144 mm
Fingerprint Sensor
Door Bell Key

Illustration for placing finger

Correct method
(Straighten your finger and then place it on the sensor ensuring the finger is down flat and covers the entire sensor windows )
Always place finger in the center of the sensor. Make sure you cover the entire sensor surface
with as much of your finger as possible.
Incorrect method :
Do not move your finger before Do not place finger away from Do not place finger Do not take off finger during the
the backlight of sensor turns off. the center of the sensor window. at an angle. fingerprint verification process.

Operation Guide

Management mode: In original state, press [OK/M] then enter the admin password (Default password：12345) to the management mode.
Press [OK/M]
Default password:12345

Add User:

SET Press [OK/M] Press [OK/M]
Enter User ID
Press【0/→】to
select FP1, FP2 or PW
Remarks: If register fails, the device will
give a long 'Beep' voice to prompt. If the
fingerprint has already been registered
the device give two 'beeps' and voice
The min&max password length is 1 to 6 digits
prompts for the fingerprint process to be
repeated.
Delete User: Press [0/→] key select [DEL.] option.
Press [OK/M]
Press [OK/M]
SET
40 mm

Keypad Instruction:

1 2 3
4 5
6
7 8 9
Num. Keys
1-9
Enter Employee ID or Password
Cancel/Power Key
Exit/Cancel the Current Operation
Power on/Power off
0/
: Select Key
Confirm/Menu Key
OK/M Confirm Current Operation
Enter System Management Menu
:
Do not use just Do not slide your finger during the
your fingertip. fingerpint verification process.
Press[OK/M] SET

Management menu

Press [OK/M]
Place same finger twice on the sensor Registration Successful
Press [OK/M]
Place same finger twice on the sensor Registration Successful
Press [OK/M] Press [OK/M]
Input user password Please input password again
Press [OK/M]
Input User ID to be deleted
Setup Date and Time: Press [0/→] to select [TIME] option: Set time and date.
SET
C/
Management password setup: Press [0/→] to select [SET.] option: Change management password.
0/
OK/M
SET
Remarks: If the second password does not
match the first. When you press
the device will give long beeps to indicate
the password changing has failed.
Other Setup
Reset: Restarts Device
Press the 'Reset' button at the buttom of the device until LCD go out.
Now release the button the device will restart.
Reset Button
Notice: Resetting will not delete any information or settings stored
in the device.

Communication with PC

TCP/IP
Press [OK/M]
Press [OK/M] Press [OK/M] Press [OK/M]
Input Date: YY-MM-DD Set Time： HH-MM-SS
Press [OK/M] Press [OK/M] Press [OK/M]
Input new management password Please Input password again
【OK/M】
Initialization: Return password to factory defaults
To initialize the device and reset the management password back to the default
password (12345) press the 'Initialization Button' until heard beeps. The operation
will not delete any user data stored in the device.
(Please verify administrator to enable
Mini-USB
the USB communication)
RS485
RJ45
V1.3
Initialization Button