Maintenance - LIFAN Power USA LF7250IPL-CA Operating Instructions And Owner's Manual

PROCEDURE
Engine Oil Check
Replace Engine Oil
Air Cleaner Filter Check
Air Cleaner Filter
Replacement
Air Cleaner Wash
Spark Plug
Valve Clearance
Fuel Tank
NOTE: Refer to Following Procedures for Proper Method to Perform Maintenance
OIL CHANGE PROCEDURES:
engine oil should be performed after each 40 hours of use of you Power Equipment Product. Check your engine
oil level prior to each use.
1. Start your engine and let it warm up to get the oil warm and thinner. Turn the engine On/OFF switch to
the "OFF" position. Turn Fuel Valve to the "OFF" position.
2. Remove the oil cap/dipstick by turning counter clockwise. Remove the oil drain plug located below the oil
cap/dipstick utilizing the appropriate tools.
USE CAUTION: THE OIL MAY BE HOT.
3. Drain the engine oil into an approved receptacle and discard in accordance with all Federal and State
Regulations. Never dump the used engine oil on the ground or into drains, only discard in an approved
manner. Check with your local authorities to determine the regulations in your area.

Maintenance

MAINTENANCE SCHEDULE
After Each 40 Hours of Use (For Initial Break in – After
First (1
When Needed or After Every 50 Hours of Use
When necessary or within 100 hrs of run time
Check & Re-‐ ‐ adjust annually or after 300 Hours of
Replace Every 3 Years Based on Condition
Refer to Controls and Feature section for diagram. Periodic Maintenance of your
TIME
Each Use
st
) 10 Hours of Use
Each Use
When Needed
Use
29