Advertisement
APPLICATIONS
WARNING
When drilling in wood, composition materials and
plastic, select the
Start the drill
slowly,
you drill. When drilling into wood, use wood augers
or twist drill bits. Always use sharp bits. When using
twist drill bits, pull the bit out of the hole frequently
chance of splintering, back work with a piece of
scrap wood. Select low speeds for plastics with a
low melting point.
When drilling in metal, select the
operating mode. Use high speed steel twist drills
or hole saws. Use a center punch to start the hole.
Lubricate drill bits with cutting oil when drilling in
iron or steel. Use a coolant when drilling in nonfer-
rous metals such as copper brass or aluminum.
Back the material to prevent binding and distortion
on breakthrough.
When drilling in masonry, select the
drill operating mode. Use high speed carbide-tipped
bits. Drilling soft masonry materials such as cinder
block requires little pressure. Hard materials like
concrete require more pressure. A smooth, even
let the bit spin in the hole without cutting. Do not
use water to settle dust or to cool bit. Both actions
will damage the carbide.
Drill a pilot hole when driving screws into thick or
hard materials. Select the
Set the torque selector collar to the proper position
and set the speed
to low.
size screwdriver bit for the type of screw you are
using. With the screwdriver bit in the screw, place
pressure before pulling the trigger. Screws can be
removed by reversing the motor.
Continuous overloading may cause permanent
damage to tool or battery pack.
drill-only operating mode.
gradually increasing speed as
,
driving screws mode.
Use the proper style and
WARNING
-
for ALL
Keep your tool, battery pack and charger in good re-
pair by adopting a regular maintenance program.
After six months to one year, depending on use,
return the tool, battery pack and charger to
authorised
spindles, bearings, housing, etc.)
motor)
drill-only
electrical operation
If the tool does not start or operate at full power
with a fully charged battery pack, clean the contacts
on the battery pack. If the tool still does not work
properly, return the tool, charger and battery pack,
to
an
authorised
WARNING
hammer
Clean dust and debris from charger and tool vents.
Keep tool handles clean, dry and free of oil or grease.
Use only mild soap and a damp cloth to clean the
tool, battery pack and charger since certain cleaning
agents and solvents are harmful to plastics and other
insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household deter-
combustible solvents around tools.
For repairs, return the tool, battery pack and char-
ger to the nearest service center.
WARNING
For a complete listing of accessories refer to your
MILWAUKEE Electric Tool
To obtain a catalog, contact your local authorised
MILWAUKEE dealer.
6
MAINTENANCE
n authorised MILWAUKEE dealer
MILWAUKEE dealer for:
MILWAUKEE dealer.
ACCESSORIES
catalog.
an
-
-
Advertisement
