Advertisement
3.
rotate the application selector col-
lar until the drive symbol
pears in line with the arrow. Then
rotate the torque selector collar
until the desired clutch setting ap-
pears in line with the arrow.
The adjustable clutch, when properly adjusted,
will slip at a preset torque to prevent driving the
screw too deep into different materials and to
prevent damage to the screw or tool.
values obtained with a fully charged battery pack.
Nm
1-5
0.5-2.8
Small screws in softwood.
6-10
3.2-4.4
Medium screws in softwood or small
screws in hardwood.
11-15
3.6-7.7
16-20
8.2-9.5
Large screws in softwoods. Medium
screws in hardwood or large screws in
21-24
9.7-10.8
hardwood with pilot hole.
Because the settings shown in the table are only
a guide, use a piece of scrap material to test the different
clutch settings before driving screws into the workpiece.
The speed selector is on top of the motor housing.
Allow the tool to come to a complete stop before
changing speeds. See "Applications" for recom-
mended speeds under various conditions.
1. For
speed, push the speed selector to
display "1".
2. For
speed, push the speed selector to
display "2".
The control switch may be set to three positions:
forward, reverse and lock. Due to a lockout mecha-
nism, the control switch can only be adjusted when
the ON/OFF switch is not pressed. Always allow
the motor to come to a complete stop before using
the control switch.
For
(clockwise)
rotation, push in the control
switch from the right side of
the tool.
For
(counterclock-
wise) rotation, push in the
control switch from the left
side of the tool.
To
the trigger, push the
control switch to the center
position. The trigger will not work while the control
switch is in the center locked position. Always
lock the trigger or remove the battery pack before
performing maintenance, changing accessories,
storing the tool and any time the tool is not in use.
ap-
-
CENTER
WARNING
1. To
pull the trigger.
NOTE: An LED is turned on when the trigger is
pulled.
2. To
the speed, increase or decrease the
pressure on the trigger . The further the trigger
is pulled, the greater the speed.
3. To
the tool, release the trigger. Make sure
the bit comes to a complete stop before laying
the tool down.
pressure before starting. Too much pressure will
pressure will cause the bit to slide over the work
area and dull the point of the bit.
If the tool begins to stall, reduce pressure slightly
to allow the bit to regain speed. If the bit binds,
reverse the motor to free the bit from the workpiece.
5
Advertisement
