Table of Contents
Advertisement
• Enter a code/Change your code:
code from the code entry screen. To enter a code for the first time, follow this
procedure. When told to enter your current code, simply enter the default
code: 0000.
NOTE:
1. From the code entry screen, use
code.
2. When the correct code is entered, press and hold down
CLEAR
CHG (change) appears in the display to indicate that you may now enter a
new code.
3. Use
4. When the new code is entered, press
The unit saves the new code. The clear all log data screen appears.
NOTE:
Clear All Log Data Screen
The clear all log data screen allows you to perform a "total clear" function which
erases all data for every day in your log at once.
1. Press and hold down
The word CLR (clear) appears in the display to indicate that the unit is prepar-
ing to clear all log data. To protect against accidental clearing of data, you must
press and hold down SET/CLEAR for 3 seconds before the unit clears data.
Whenever you enter a new code, make sure you write it down and file it.
.
Change Code Mode
"+"
and
"-"
to enter a new code.
If you need to check the code you just entered, simply press
return to the code entry screen. Once entered, the correct code appears on this screen
until you return to the group of data screens.
SET/CLEAR
Clearing Mode Indicator
You may enter a code or change your
"+"
and
"-"
CODE
SETTINGS
MODE
SETTINGS
CLEAR LOG
.
SETTINGS
CLEAR LOG
to enter your current
SET/
.
MODE
until you
Page 19
Advertisement
Table of Contents
