Makita DTD170 Instruction Manual page 9

Impact force grade displayed
on panel
NOTE:
NOTE:
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
NOTE:
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
socket bit.
For tool with shallow driver bit hole
For tool with deep driver bit hole
Maximum blows
-1
3,800 min
bit. Follow the procedure
1. (Note) Bit-piece is not
necessary.
To install these types of driver
bits, follow the procedure 1.
To install these types of driver
bits, follow the procedure 2.
(Note) Bit-piece is necessary
for installing the bit.
Purpose
Tightening screws with better
control.
Procedure 1
For tool without one-touch type sleeve
1
1. Driver bit 2. Sleeve
To install the driver bit, pull the sleeve in the direction of
the arrow and insert the driver bit into the sleeve as far
as it will go.
Then release the sleeve to secure the driver bit.
For tool with one-touch type sleeve
To install the driver bit, insert the driver bit into the
sleeve as far as it will go.
Procedure 2
In addition to Procedure 1, insert the bit-piece into the
sleeve with its pointed end facing in.
1
1. Driver bit 2. Bit-piece 3. Sleeve
To remove the driver bit, pull the sleeve in the direction
of the arrow and pull the driver bit out.
9 ENGLISH
Example of application
Tightening long screws.
2
2
3