Installing Hook; Operation - Makita DTD170 Instruction Manual

NOTE: If the driver bit is not inserted deep enough
into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this
case, try re-inserting the bit according to the instruc-
tions above.
NOTE:
the sleeve and insert it into the sleeve as far as it will
go.
NOTE:

Installing hook

3
2
1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.

OPERATION

The proper fastening torque may differ depending upon
workpiece to be fastened, etc. The relation between fas-
Proper fastening torque for standard bolt
140
2
1
1. Fastening time (second) 2. Fastening torque
Proper fastening torque for high tensile bolt
200
(2040)
180
(1836)
160
(1632)
140
(1428)
120
(1224)
100
2
(1020)
(816)
(612)
(408)
(204)
1. Fastening time (second) 2. Fastening torque
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
NOTICE:
If you use a spare battery to continue
the operation, rest the tool at least 15 min.
10 ENGLISH
m
M16
M14
120
100
M12
80
60
M10
40
M8
20
0 1
1
m
M14
M12
M10
80
M8
60
40
20
0 1 2
1
M16
M14
M12
M10
M8
2
M14
M12
M10
M8
3