Advertisement
Status Lights
Solid Green Light - Lamp is paired and receiving transmission.
Slow Flashing Green Light - Wireless DMX is paired but transmitter not found.
Fast Flashing Green Light - Wireless DMX is in pairing.
No Green Light - Lamp is Unpaired or Wireless/Status Lights are turned off.
Solid Red Light - Data Received
No Red Light - No Data Received or Wireless/Status Lights are turned off.
Manual Button Shortcuts
On parameter menus such as intensity, saturation, and hue, when pressing and holding the
button to increase the value, tap the
opposite is true when decreasing.
Press and hold the Enter
M
M M
M M
M M
M M
M M
M M
M
M M
Lead/Follow Mode
M
M M
M
M
M
M
M
Lead/Follow Mode allows one Rainbow lamp to control many lamps at once. The Lead transmits
DMX data wired or wirelessly to the followers. When the Lead changes levels, the follows will
change as well. Applies to on board FX as well.
MODE
Data
Follow 1
To Lead/Follow Mode, go to Config->Lead/Follow. Set the Leader to Lead and set all of the
DMX
-
+
Followers to Follow 1 to match the leader. Follow 2-6 is used with effects to do the same effect with
different timings.
MODE
Data
To use wired, plug Cat5 cable into the Out of the Lead into the In of the Follow. Repeat out of the
Follow 1
DMX
-
+
follow and into the next. The data light should be illuminated on all the followers
To use wirelessly, on the Follows, press and hold the Link button
the Link button
MODE
Data
Lead
DMX
then remain solid.
-
+
Effects
Effect
Result
Rainbow
Scroll through the Hue from 0° at full Saturation
Short Circuit
Lamp is on with random bursts of turning off
Paparazzi
Lamp is off with random flashes of turning on
Fire 1
A flicker effect with a low weighted center
Fire 2
A flicker effect with a middle weighted center
Fire 3
A flicker effect with a high weighted center
Cop Light 1
Solid Red and Blue alternating colors
Cop Light 2
3 Flashes Red, 3 Flashes Blue alternating colors
Demo
Scroll through the Hue from 0° at 0%, 25%, 50%,
75% and 100% Saturation at 2000k and 6000k
-
button will jump to the next value or max value. The
for 5 seonds to disable the status lights.
on the Lead. All of the follows Wireless signal light should begin flashing and
Q-Rainbow RGBX
to Unpair the lamp. Next tap
Manual Effect Controls
Result
Effect
Effect
Choose Effect
Rate
0-200% for the speed
of the effect
100% is normal speed
Maximum
Highest intensity level
of effect
Minimum
Lowest intensity level
of effect
Linear LED
Data
DMX
+
Advertisement
