TP-Link TL-WR841N Quick Installation Manual

Quick Installation Guide
Multi-mode Router
Meet all your needs.
TL-WR841N
If your internet connection is through
an Ethernet cable directly from the wall,
instead of through a modem, connect
the Ethernet cable to the router's WAN
port, and skip Step 1,2,3.
Confirm that the following LEDs are on and solid
to verify the hardware connection is correct.
Power Wi-Fi Internet
On On On
Note: If the Wi-Fi LED is not on, please press the WIFI ON/OFF button
on the back panel for about 4 seconds, and then the LED should turn
solid on in a few seconds.
ON/OFF ON/OFF POWER POWER WAN WAN
Power adapter
Connect the power adapter to
the router and turn on the router.
Configure the router
1.
Connect your computer to the router (Wired or Wireless)
Wired
Turn off the Wi-Fi on your computer and connect it to the router's LAN
port via an Ethernet cable.
Wireless
Connect your device to
the router's Wi-Fi using the
SSID (network name) and
wireless password printed
on the label at the bottom
of the router.
WPS/ WIFI
WPS/ WIFI
1 1 2 2 3 3 4 4 RESET RESET ON/OFF ON/OFF
Router
Connect the modem to the router's
WAN port via an Ethernet cable.
Wireless Password/PIN:XXXXXXXX
SSID:TP-Link_XXXX
Turn off the modem, and remove
the backup battery if any.
Turn on the modem and then wait
about 2 minutes for it to restart.
Modem
2.
Launch a web browser, enter http://tplinkwifi.net or http://192.168.0.1
in the address bar. Use admin for both username and password, and
then click Login.
Note: If the login window does not appear, please refer to FAQ > Q1.
3.
Click Next to start the Quick Setup. Select Wireless Router and follow
the step-by-step instructions to set up the internet connection.
Note: If you are not sure of the WAN Connection Type, please click Auto-Detect.