Table of Contents
Advertisement
Wiring
The LCD Touch Switch is wired to a RAPIX™ eHub via standard Cat5/5e cable (up to 100m), with a plug in
patch lead at each end. There are no additional screw-down terminations required.
The eHub powers the LCD Touch Switch via the above Cat 5/5e connection. The LCD Touch Switch does not
require a separate power supply.
Configuring and Commissioning
The LCD Touch Switch is configured using RAPIX™ Integrator Software. Contact Diginet for further details.
Specifications and standards compliance
Product specifications
Screen Size
Screen Resolution
Colour depth
Pixel Pitch
Brightness
Contrast Ratio
Touch Overlay Type
Connection
Display Viewing Area
Weight
Number of control buttons
Operating Temp. Range
Operating Humidity Range
Compliance Marks
A patch lead with a
RED
used at the LCD Touch Switch
A patch lead with a
BLUE
used at the eHub
3.5"
480 x 320 pixels
65K
0.153(H)mm x 0.153(V)mm
220cd/m
(configurable in software)
2
500:1
Resistive
Connects to eHub using RJ11/RJ12 patch lead or RJ45 patch lead
49mm x 73mm
80g
Configurable for 1 – 20 buttons
Single page: up to 6 buttons
Multiple Pages: up to 5 buttons per page
0 – 50⁰C
10% - 95% RH non condensing
ROHS, WEEE, CE, RCM
LCD Touch Switch
female RJ-45 socket must be
female RJ-45 socket must be
Page | 5
Advertisement
Table of Contents
