Check-line NS-600 Operating Manual

Led stroboscope

Table of Contents

Download this manual

Enlarged version

2 YEAR WARRANTY

(RESTRICTIONS APPLY)

Hoto Instruments warrants its products to the original purchaser to be free from defects

in workmanship and material under normal use and proper maintenance for two years

(one year for attachments, adapters, batteries and cables) from original purchase. This

warranty does not cover calibration and shall not be effective if the product has been sub-

ject to overload, shock load, battery overcharge, misuse, negligence, accident or repairs

attempted by others than Hoto Instruments.

During the warranty period, we will, at our option, either repair or replace defective

products. Please call our customer service department for a return authorization number

and return the defective product to us with freight prepaid.

The foregoing warranty constitutes the SOLE AND EXCLUSIVE WARRANTY, and we

hereby disclaim all other warranties, express, statutory or implied, applicable to the products,

including but not limited to all implied warranties of merchantability and fitness. In no

event shall Hoto Instruments be liable for any incidental or consequential damages.

02/12

Distributed by: ABQ Industrial LP USA

Tel: +1 (281) 516-9292 / (888) 275-5772 eFax: +1 (866) 234-0451

Web: https://www.abqindustrial.net E-mail: info@abqindustrial.net

CHECK•LINE

Model NS-600

LED Stroboscope

Operating Manual

BY ELECTROMATIC

Table of Contents

Need help?

Do you have a question about the NS-600 and is the answer not in the manual?

Page 1 Hoto Instruments. Model NS-600 During the warranty period, we will, at our option, either repair or replace defective products. Please call our customer service department for a return authorization number and return the defective product to us with freight prepaid.
Page 2 1 fpm/rpm (over 100,000 display flashes) Introduction .20 ~ 999.00 Hz 0.01 Hz Model NS-600 is an enhanced LED, battery operated, stroboscope 1000.0 ~ 2000.0 Hz 0.1 Hz designed to measure and observe rotating, reciprocating and linear motion in a large variety of production, quality control and academic Specifications applications.
Page 3 PROGRAM MODE DISPLAY Changing Units –SEL– Turn off the strobe. Press and hold the POWER SWITCH ● CLICK AND RELEASE TO TURN ON, key, then press the switch. MODE POWER CLICK TO TURN OFF. AUTO SHUT OFF AFTER 10 MINUTES SEL is displayed.
Page 4 If released after two seconds the strobe shuts off. shown on the display. The strobe powers off after five minutes of non-use. 3. Set flash rate to maximum and aim the NS-600 at the object. To find true rpm, lower the flash rate until the first time a single mark appears.