Table of Contents
Advertisement
Installation and user manual
C. Installation
Before installing
Installation and startup of this appliance is extremely simple, however, you should read all the instruc-
tions and recommendations detailed in this instruction manual and recommendations carefully, as the
manufacturer will not be held liable for damage caused by non-compliance.
Once the appliance is unpacked, the packaging must be removed responsibly since all the elements have
been designed for recycling. If on unpacking, you discover any damage whatsoever, please get in touch
with your supplier prior to installation.
For assembly and installation, please follow the instructions as set out in this booklet. For safety reasons,
this heater should never be installed in close proximity to a bath or shower i.e. that you could touch the
controls whilst in the bath or shower. The radiator should not be placed below a socket. If the cable has
been damaged, it can only be replaced by the manufacturer, through its aftersales team, or by a qualified
person. This ensures the user will not be in any danger. At the end of the manual, you will find a Guaran-
tee, please check that this has been completed correctly, dated and stamped.
Connecting electricity supply
-If the radiator that you have purchased does not have a plug on the supply cord, installation should
be carried out by a qualified electrician.
-Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules
of the country where it is to be installed.
-Before connecting, check the supply is switched off.
-Before connecting the appliance to the fixed wiring check that the voltage of supply is inside the rated
values indicated in the marking plate 220 - 240V.
-The appliance must be connected to the fused system of fixed wiring.
-Any problem arising from not following the instructions above will invalidate your guarantee
-When wiring up, please follow the colours of wires.
Power supply
Connect the electric radiator with the switch installed for this function.
When the thermostat is switched on for the first time, you will be asked to make some necessary selec-
tions (Clock, etc.). The batteries inside the thermostat will need to be charged for a minimum of 24 hours
in order to have maximum time saving capacity.
D. Operating instructions
Modes
The radiator can work at 3 different modes:
• Auto. The setpoint temperature varies automatically according to customizable programming based
on 3 temperatures (operation as programmable thermostat chronothermostat). The bars report the
temperature that is programmed for each hour.
- Manual.The setpoint temperature remains fixed, depending on the user's choice (operation as digital
thermostat).
-
-
4
Hide quick links:
Advertisement
Table of Contents
