Display Assembly - HP EliteBook 846 G5 Maintenance And Service Manual

Display assembly

NOTE: Display assemblies are spared at the subcomponent level only. Display assembly spare part
information is also available at
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the display assembly:
1. Disconnect the antenna cables from the WWAN module (1) and the WLAN module (2).
2. Remove the antenna cables from the clips built into the computer (3).
3. Disconnect the display cable (4) and the camera cable (5) from the system board.
4. Remove the cables from the clips built into the computer (6).
5. With the computer upside down, open the display, and then place the computer on a table with the
display positioned off the edge of the table.
6. Remove the five Phillips M2.5×5.0 screws (1) from the display hinges.
Display assembly subcomponents on page
Bottom cover on page
24.
32).
Battery on page 45).
Component replacement procedures 67