Table of Contents
Advertisement
INSTALLATION
1. Insert a stiff wire or an awl through the hole (C), Figure
166, on the inside of the door opposite the cylinder opening.
2. Place recessed end of lock shaft on the end of the wire and,
keeping the two firmly together, press the lock assembly
into the door using the wire as a guide.
3. Press the lock retainer into position by hand as far as
possible, then, using a fibre hammer, drive the retainer in
flush with the door.
DOOR LOCK REMOTE CONTROL
REMOVAL
1. Remove all door trim panels, Page 108.
2. Remove three screws (E), Figure 168, from triangular
bracket (F) at the handle end of remote control arm.
3. Remove anti-rattle spring (D) and pin from lock end of
remote control arm and remove remote control.
INSTALLATION
To install, reverse procedure of removal.
FIGURE 168
DOOR LOCK
REMOVAL
1. Remove door outside handle, Page 109.
2. Remove door lock cylinder assembly.
3. Remove all door trim panel. Page 108.
4. Raise window and remove window guide channel screws
(B and C), Figure 168, and remove channel by pulling
channel down.
5. Remove three large Phillips head screws (A) attaching
lock to edge of door.
6. Remove remote control anti-rattle spring
connecting remote control arm to lock.
7. Remove lock down through lower opening of door inner
panel.
INSTALLATION
To install, reverse procedure of removal.
LOCK LUBRICATION
Whenever door locks, lock cylinders, or remote control
arms are removed, they should be cleaned and lubricated
before replacement. Special Hudson "Lock Ease" lubricant
should be used to insure operation in cold weather. Ordi-
nary oils and greases are not suitable for lock mechanisms.
To prevent the remote control arm from freezing and stick-
ing, lubricate the arm under the silencer sleeve and the
outside of the sleeve that contacts the door inner panel.
FIGURE 169
CONVERTIBLE TOP AND REAR
CURTAIN
REMOVAL
Rear curtain removal includes items 1 thru 6. Top and
rear curtain r e m oval includes items 1 thru 8. Removal of
top decking only includes items 1. 2, 3, 4, 7 and 8.
1. Remove snap fasteners and chrome moulding from rear
belt line (A), Figure 169.
BODY MANUAL
110
(C) and pin
Advertisement
Table of Contents
