Countertop water filter clean water machine (8 pages)
Summary of Contents for Aquasana OptimH2O AQ-RO-3
Page 1
Reverse Osmosis plus Claryum ® Filtration Technology Welcome to the Aquasana experience. You are about to enjoy clean, clear water and the peace of mind that comes from knowing award winning filter technology is working for you. System tested and certified by NSF...
REQUIRED TOOLS & MATERIALS WARNING: Using a qualified installer is recommended. • Basic plumbing knowledge • 1/ 8 " & 7/ 3 2" Drill Bits/Drill • Pencil Proper installation is the responsibility of the installer. • Tape Measure • Adjustable Wrench •...
Page 3
1 — INSTALL BRASS TEE FITTING 2 — INSTALL SYSTEM MANIFOLD 1 Turn off the cold water supply to the sink. 1 Select an easily accessible area under the sink to mount system 2 Turn on the kitchen faucet to release pressure and allow water to drain from the line. manifold and remineralizer holder.
Page 4
4 — INSTALL RO FAUCET 5 — INSTALL RO DRAIN CONNECTOR You will need a sink top hole 1" in diameter. If drilling a new hole, ensure faucet body will WARNING CAUTION mount flat against surface and that there is sufficient tubing between faucet body and system manifold.
6 — CONNECT TUBING I: Brass Tee to Manifold “INLET” (1/4" white tubing) 1 Take the white tubing leading from the brass tee and insert it into the manifold port labeled “INLET”. Remember to push it all the way in until it stops. II: Manifold to Remineralizer (3/ 8 "...
7 — STEP 1–3 FILTER INSTALLATION 8 — SANITIZE, TEST & PURGE Sanitize Before you begin: make sure the cold water valve is shut off and there is no pressure in the system. Carbon (red) and Claryum (yellow) filter cartridges will come pre-installed in their cartridge sumps. Note: Sanitization is recommended immediately after RO Filter System installation and any inner-part servicing.
Specifications – Qualified System Performance 3-STAGE RO SYSTEM – MODEL AQ-RO-3 Because the performance of a Reverse Osmosis Membrane is highly dependent upon pressure, U.S. Metric temperature and TDS, the following should be used for comparison purposes only. Membrane Production 35 gpd 132 lpd 1 Industry standards measure RO Membranes performance with no back pressure on the...
Page 8
If a leak occurs, shut off the water supply, open up the filter faucet to release pressure from the system & contact Aquasana Lower temperatures are directly proportional to slower flow rate. All membranes are tested at Technical Support 866.662.6885.
This system is to be used on water supplies containing a detectable free chlorine Manufactured by: Aquasana, Inc. 6310 Midway Road · Haltom City, Texas 76117 · 866.662.6885 residual at the system inlet or on water supplies that have been demonstrated to contain only pentavalent Testing Performed under NSF/ANSI Standards 42 and 53 and in accordance with the California Department of Health Services Drinking Water Treatment Device Program.
Page 10
Aquasana Aquasana parts. This includes, but is Limited Warranty and is not necessary All Aquasana products offer a 90-day satisfaction guarantee. (A 2 year warranty is included, not limited to: replacement filters, for factory direct purchases made faucets, and diverter valves.
Page 11
6310 Midway Road Haltom City, Texas 76117 Aquasana, Inc. For exclusive deals facebook.com/aquasana 6310 Midway Road · Haltom City, Texas 76117 twitter.com/aquasana 866.662.6885 USA · 877.332.7873 Canada www.aquasana.com System tested and certified by NSF The AQ-RO-3 system has been tested and...
Need help?
Do you have a question about the OptimH2O AQ-RO-3 and is the answer not in the manual?
Questions and answers