jablotron DAVID GD-04 User Manual page 7

Additional functions
NPC, xx...x
New access code
STS, xx..x
SMS to get David's status
STN, x..x, x..x
Service tel. numbers
DIP,a,b,c,d,e,f,g
Optional functions
CAX, xx..x
DTMF code to switch relay
2
ON
CDX, xx..x
DTMF code to switch relay
2
OFF
LRN,n,xx..x,n,x.
Wireless device
3
assignments
GSM
Triggering re-registration to
the GSM network
RST
Reset
1
Only available for the GD-04A version
2
Only available for the GD-04D version
3
Only available for the GD-04R version
xx...x = new access code, 2 to 8 characters
Example: NPC, MARTIN27
xxx..x = text, up to 30 characters
Example: STS, HOW ARE YOU NOW
xxx..x = tel. number. Up to 2 numbers can be set,
previously set numbers are erased. Service
numbers are used to report faults:
1
POWER FAIL / POWER RECOVERY
LINE OK (GSM signal recovery)
THERMOSTAT FAILED lost communication
LOWBATT low battery in any wireless device
Other events – see Optional functions.
Instruction STN, erases service number(s).
Parameter a to f values can be:
1=ON, 0=OFF, x=unchanged
Description of the parameters:
a Forward unrecognised SMSes to the service
number (including phone number)
b Periodic calls to the service number every 24
hours (from the moment of being set)
c Forward all SMSes to the service number
d Max. 10 SMSes within 15 minutes (all
subsequent SMS requests ignored)
e SMS reporting of relay dialling-in-control
f SMS reporting of relay SMS control (e.g.
heating off OK)
g Input terminal GND connection disables any
wireless connection to the input (not applicable
to thermostats) Example: DIP,1,x,x,x,x,1,x
Use CAY for relay Y.
xx..x = numeric code, up to 8 digits
Example: CAY, 1234
Instruction CAY, erases the code.
Use CDY for relay Y.
xx..x = numeric code, up to 8 digits
Example: CDY, 1234
Instruction CDY, erases the code.
n = A, B, C, D, X or Y (input or output the device
should be assigned to)
xx..x = device production code (last 8 digits)
Only one device can be assigned to each A to D
input, whereas each of X or Y relays can have up
to 4 devices enrolled. Example: LRN,A,xx..x,B,
xx..x, X,xx..x Instruction LRN, erases all
assignments. A device cannot have multiple
assignments. The order of A to Y is arbitrary, no
duplications are allowed.
David will unregister and then re-register to the GSM
network. This can be useful after a blocked SIM card
has been unblocked. A re-registration is also triggered
by briefly connecting the RESET jumper while David
is being powered up.
Resets David to the factory default settings.
This can also be performed by connecting the
RESET jumper during powering up – disconnect
the jumper after approx. 5 sec.
PC
STATUS
none
0000000
(all OFF)
none
none
none