Bush Hog 1812 Operator's Manual page 99

Uneven Cut
Uncut Material
Poor Shredding
Windrowing or Uneven
Material Distribution
1812 08/14
© 2012 Alamo Group Inc.
OPERATION
Excessive ground speed.
Blades worn, dull, or bent.
Mower not level side to side.
Improper height adjustment.
Low tractor tire pressure on one side. Adjust tire pressure.
Turning too fast.
Tractor tires push grass down.
Damaged Mower pan.
Excessive ground speed
RPM too low
Improper blade for direction of cut.
Excessive ground speed.
Cutting too high.
Material heavy and lush.
Excessive ground speed
Conditions too wet.
Operation Section 4-49
Reduce ground speed.
Replace blades.
(Refer to "Maintenance" section).
Adjust. (Refer to "Assembly" section)
Adjust Mower height.
(Refer to "Assembly" section)
(Refer to your tractor
operator's manual)
Reduce ground speed when turning.
Adjust your tractor wheel spacing.
(Refer to "Operation" section)
Repair or replace as necessary.
Reduce ground speed.
Use full PTO speed.
(Refer to your tractor
operator's manual)
Install blades so rotation is correct.
Raise the front of Mower relative to the
rear to hold and circulate material
longer. (Refer to the "Operation
Section-Setting the Mower-
Setting Deck Height") Reduce ground
speed.
Lower cutting height. (Refer to the
"Operation Section-Setting the Mower-
Setting Deck Pitch")
Raise the front of Mower relative to the
rear. (Refer to the "Operation Section-
Setting the Mower- Setting Deck
Height")
Reduce ground speed.
Wait for conditions to dry. Reduce
ground speed.