Advertisement
Let the search coil approach the ground without any metals, if the unit sounds a
tone, please repeat the above operation (Release and then press the TARGET button
again) until the detector does not sound a tone.
Slowly move the search coil in the region that you find target object, In the
position that the detector will sound a tone. Continue moving the search coil slowly
until the sound reaches the loudest.
Maintain the position of the detector, release the TARGET button for several
seconds. Press the TARGET button again, the detector is self-balanced, and the unit
won't sound a tone any more. Then move the search coil again to make the sound
more louder.
Repeat the operation, until you pinpoint the location of the metal target.
7. The application of no-motion mode
In fact, directly using the no-motion mode to find metal objects is also effective.
Just press and hold down the TARGET button to carry through and detect, without
adjusting the DISC and SENS. In some areas, as the ground is uneven, the space is
too narrow, you should not use search coil, and you should choose no-motion mode.
In the severe mineralization or salinization district, you could try using no-motion
mode directly. Please note when pressing the TARGET button, the DISC/TONE and
SENS knob are no longer functional. And the detector will respond to all kinds of
metals.
Caution
In areas with heavy traffic, please don't wear earphone, in case an accident
occurs.
Always obtain permission before searching any site.
Keep away from the regions that may contain buried electrical line, cable line
or pipeline, in particular the pipes that are full of flammable gases and liquids.
Do no detect in the military area where there may be buried bombs or gas
explosives.
When digging out the target, use the reasonable method, do not destroy the
vegetation. Leave the land and vegetation as it was after excavation.
Advertisement
