Verifying Qos Configuration - Cisco Nexus 5000 Series Configuration Manual

Configuring QoS
DETAILED STEPS
Command or Action
Step 1
switch# configure terminal
Step 2
switch(config)# hardware unicast voq-limit
Step 3 switch(config)# no hardware unicast voq-limit
This example shows how to enable the VOQ limits for unicast packets on a switch:
switch(config)# hardware unicast voq-limit
switch(config)#

Verifying QoS Configuration

To verify QoS configuration information, perform one of these tasks:
Command
switch# show class-map
switch# show policy-map [name]
switch# show policy-map interface [interface
number]
switch# show policy-map system
switch# show policy-map type {network-qos | qos
| queuing} [name]
switch# show queuing interface [interface number]
You can clear the QoS policy statistics.
Command
switch# clear qos statistics
OL-20921-01
Purpose
Enters configuration mode.
Enables the VOQ limit for unicast traffic. The default
is disabled.
Disables the VOQ limit for unicast traffic.
Purpose
Displays the class maps defined on the switch.
Displays the policy maps defined on the switch.
Optionally, you can display the named policy only.
Displays the policy map settings for an interface or
all interfaces.
Displays the policy map settings attached to the
system qos.
Displays the policy map settings for a specific policy
type. Optionally, you can display the named policy
only.
Displays the queue configuration and statistics.
Purpose
Clears the policy statistics.
Cisco Nexus 5000 Series NX-OS Quality of Service Configuration Guide
Verifying QoS Configuration
45