Configuring Routing Between Pes - HPE FlexNetwork 5510 HI Series Mpls Configuration Manual

Step
8. (Optional.)
reflection between clients.
9. (Optional.)
cluster ID for the RR.
2. Configure the CE:
Step
1. Enter system view.
2. Enter BGP view.
3. Configure the PE as an IBGP
peer.
4. Create the BGP IPv4 unicast
family and enter its view.
5. Enable IPv4 unicast route
exchange with the specified
peer or peer group.
6. (Optional.) Configure route
redistribution.

Configuring routing between PEs

Step
1. Enter system view.
2. Enter BGP view.
3. Configure the remote PE as
a BGP peer.
4. Specify the source interface
for route updates.
5. Create
address family and enter its
view.
6. Enable BGP VPNv4 route
exchange with the specified
peer.
Command
Enable route
reflect between-clients
Configure the
reflector cluster-id { cluster-id |
ip-address }
Command
system-view
bgp as-number
peer { group-name | ip-address
[ mask-length ] } as-number
as-number
address-family ipv4 [ unicast ]
peer { group-name | ip-address
[ mask-length ] } enable
import-route
[ { process-id | all-processes }
[ allow-direct | med med-value |
route-policy route-policy-name ]
* ]
Command
system-view
bgp as-number
peer { group-name | ip-address
[ mask-length ] } as-number
as-number
peer { group-name | ip-address
[
connect-interface interface-type
interface-number
the BGP VPNv4
address-family vpnv4
peer { group-name | ip-address
[ mask-length ] } enable
protocol
mask-length ]
181
Remarks
receiving side.
Route reflection between clients is
enabled by default.
By default, the RR uses its own
router ID as the cluster ID.
If multiple RRs exist in a cluster,
use this command to configure
the same cluster ID for all RRs in
the cluster to avoid routing loops.
Remarks
N/A
N/A
By default, no BGP peer is
created.
By default, the BGP IPv4 unicast
family is not created.
By default, BGP
exchange IPv4 unicast routes with
any peer.
A CE must redistribute its routes
to the PE so the PE can advertise
them to the peer CE.
Remarks
N/A
N/A
By default, no BGP peer is
created.
By default, BGP uses the egress
} interface of the optimal route
destined for the peer as the
source interface.
By default, the BGP VPNv4
address family is not created.
By default, BGP
exchange BGP VPNv4 routes
with any peer.
does not
does not