Network Settings - GE DuraStation Operation And Maintenance

DuraStation™ EV Charger User Manual

4.2.7 Network Settings

This tab is used to configure the network settings of the DuraStation.
Configuration Options in the Networking tab
Figure – 4.17
Important Note!
Cellular equipped stations will exchange the WiFi setting options with some cellular settings as
shown above. These settings are pre-set at the factory and should not be changed unless
customer wants to operate the station by Ethernet instead. In such case simply uncheck "Enable
Cell modem" and set "Network Interface to GE CONNECT" = eth0.
Be sure to hit submit after making changes, noting that some setting changes could possibly
change the IP address thereby terminate the connection to the configuration tool.
24
GE Industrial Solutions ©2014 GE Company All Rights Reserved