Explanation Of Jacks And Cables - RCA 20F510TD User Manual

Explanation of Jacks and Cables

You can connect other components to your TV/DVD player such as a VCR, video camera, or audio receiver. There
are several ways to connect other components to your TV/DVD player depending upon the cables you have
and the jacks that are on the back of the components. Different jacks and cables provide a different level of
performance. The jacks on the back of your TV/DVD Player and the cables used to connect them are explained
below.
Note: If you do not connect a cable, antenna, or another component to your TV, the TV will automatically shut off after
15 minutes to save power.
Connections and Setup
VIDEO Jack and Cable
The basic Video jack (usually color-coded yellow) is also referred to as
composite video. Composite video is better than the video quality you get from
an RF coaxial cable (the type used to plug the cable feed into a TV). Usually the
video cable is bundled with the audio cables (color-coded white and red).
S-VIDEO Jack and Cable
The S-VIDEO (separate video) jack provides better picture quality than
composite video (the VIDEO jack) because the color is kept separate from the
black and white part of the video signal.
Note: Remember to connect the audio cables because the S-Video cable carries only
the picture signal, not the sound.
AUDIO L (left) and R (right) Jacks and Cables
These jacks are used for audio connections of other components to the TV. The
audio jacks and cables are often color-coded (red for right audio, and white for
left audio). You must connect audio cables to the AUDIO L and R jacks on the
TV/DVD player and the corresponding jacks on the component no matter which
Video jack [AV1 (SVID), DVD, AV3 (side front)] you connect.
Note: If your component has only one audio output for audio (mono), connect it to
the left (white L/Mono) audio jack on the TV and don't connect the right audio part
of the cable.
Connections and Setup
3