Complete The Initial Setup; Complete Auto Channel Search - RCA 12L500TD User Manual

Complete the Initial Setup

The menu systems in your TV/DVD allow the unit's features to work properly. You'll need to set a few
important menu items the first time you turn on your TV/DVD.
MAIN M E NU
SELECT VIDEO
S E T P IC TU R E
AUTO - PROGRAM
ANTENNA INPUT
ANTENNA
AIR
STD
IRC
HRC
Tip
You can also program the available channels by
pressing the AUTO PROGRAM button on the
remote. You still need to set the ANTENNA INPUT
in the menu for the type of signal you have first,
however.
Chapter 1
Chapter 1: Connections & Setup

Complete Auto Channel Search

This part of the setup allows the TV to search for all channels viewable through your
antenna or cable TV system. This is sometimes called auto programming.
1. Make sure the remote is in the TV mode by pressing the TV button.
2. Press MENU (the Main menu appears).
3. Press the down arrow button until ANTENNA INPUT is highlighted, and press
ENTER (the ANTENNA menu appears).
4. Press the down arrow button to highlight AIR (for an off-air antenna), STD (for
standard cable), IRC, or HRC depending on the type of signal you have. Then press
ENTER.
5. Press MENU again (the Main menu appears).
6. Press the down arrow button until AUTO-PROGRAM is highlighted, and press
ENTER to begin the auto channel search. This may take several seconds.
Once the search is complete, you can begin watching TV. To add or delete any channels,
go to page 33.
13