*2: Select "Off" to avoid entering standby mode when there is no input signal.
*3: This varies depending on the "Lamp Mode" setting.
*4: As the lamp is dimmed gradually, you may not notice any change in brightness. You might only
notice that the lamp has dimmed when its brightness is restored after there is a change in input
signal.
*5: This mode does not work for about three minutes after the lamp lights. A change in signal may
not be detected depending on the input image. The lamp may become brighter at intervals if you
continue to use the projector during lamp dimming. However, this is not a malfunction. If With
No Input is set, it takes priority.
*6 If it is set to "On," "Auto" cannot be selected in "Auto Power Saving" or "With No Input."
26
The Connection/Power Menu