Aqua One Regency 100 Assembly Instructions

Step 6: Hood W, aquarium U and cabinet
X
cover
hood
W
light
V
glass tray
heater
U
canister
filter
Important Notice
It is absolutely imperative that you ensure this cabinet and aquarium is installed upon level flooring. It is also a prerequisite that
you ensure the flooring upon which it is positioned is able to support the weight of this aquarium which could be up to 600kg
including water and decorations.
Installation upon uneven flooring will result in poor distribution of weight. Damages to the aquarium, cabinet or equipment and
damages caused by leaks due to improper or uneven installation are not covered by the guarantee with this product.
Care and Maintenance of your Aqua One Aquarium
Glass: It is recommended that you use a good quality glass cleaner and a non abrasive lint free cloth. Glass cleaner should only
be used on the outside of the aquarium.
To clean the glass on the inside of the aquarium, it is recommended that you use an Aqua One Scraper or Magnetic Cleaner
(available from your local Aqua One dealer).
Cabinet and Hood: The use of a damp cloth is recommended, do not use any detergents or harsh chemicals to clean the cabinet
and hood as damage may occur.
Precision Manufactured in the P.R.C. Distributed in New Zealand by:
Designed in Australia by Aqua One Kong's (NZ) Limited
Distributed in Australia by: 52 Glenlyon Avenue.
Kong's (Aust.) Pty. Limited Greerton. Tauranga New Zealand.
48 Williamson Rd. Ingleburn.
2565 NSW Australia.
®
Aqua One and Kong's are registered trademarks. www.aquaone.com.au.
U
Place aquarium on top of
cupboard by lifting it on from
the back and sliding it forward.
VERY IMPORTANT: DO NOT REMOVE THE
POLYSTYRENE ATTACHED TO THE BOTTOM
OF THE AQUARIUM!
Install Filter (see filter instructions for details)
Install Heater (see heater instructions for details)
V
Put glass tray on top of aquarium.
Install reflector lighting (see lighting instructions
for details)
W
Slide hood onto aquarium. Insert maintenance
X
lid into the hood.
Distributed in the UK by:
Kong's (UK) Ltd.
C/O Aqua Pacific UK Ltd.
PO Box 268
Romsey Hampshire
S051 0WW
United Kingdom
©
Aqua One 2004
Instruction version:- 22/02/2008
Regency 100
Assembly instructions
Top back
L
panel x 1
Lower back
K
panel x 1
O
Top of Cabinet
Shelves
x 2
R
U
Glass Aquarium x 1
V
Glass tray x 1
Parts Required
Tools required:
Contents:
Ax16 Bx16 Cx8 Dx2
Ex2 Fx16 Hx4 Zx8
I
Base x 1
M N P
Left side x 1 Right side x 1 Left door x 1
W
Hood x 1
X
Hood Insert x 1
Glass Lids x 2
J
Centre Panel
x 1
Q
Right door x 1