Advertisement
Assembling The Mounting Bracket
The ANT2020 consists of an off-air bracket and hardware, an
offset mast, and eleven inch extension, and a swaged tube for
non-vertical mounting. The bracket may be used with a satellite
dish or alone to mount this off-air antenna.
For vertical mounting, place the off-air bracket behind the Satellite
Mounting Bracket and follow the mounting instructions that came
with the satellite system. Insert eleven inch extension into offset
mast. Drill a hole through both and secure the two together with
#10 self tapping screw. With the bracket secured to the wall or
other vertical surface, mount the offset mast assembly to off-air
bracket using U-bolts, mast clamps, lockwashers, and nuts as
shown. Adjust the offset mast assembly so the off-air antenna is
horizontal and does not interfere with the DBS antenna.
The off-air bracket may be used alone to mount an off-air anten-
na. Mount the off-air bracket to the wall with the four lag bolts
supplied and mount the offset mast to off-air bracket as shown.
Offset Mast
#10 Self
Tapping Screw
11" Extension
Offair Bracket
Nuts
Lockwashers
Dish Mouting Bracket
Vertical Mounting
Dish
Lag Bolts
U-Bolts
Mast Clamps
For non-vertical mounting, place the off-air bracket behind the
Satellite Mounting Bracket and follow the instructions that came
with the satellite system. With the off-air bracket secured to the
non-vertical surface, mount the swaged tube to the off-air brack-
et using U-bolts, mast clamps, lockwashers, and nuts shown.
Mount offset mast to swaged tube. NOTE: If additional off-air
antenna height is needed or desired, insert eleven inch extension
into offset mast. Drill a hole through both and secure the two
together with #10 self tapping screw. Adjust the swaged tube and
offset mast/offset mast assembly so the off-air antenna antenna is
horizontal and the mast does not interfere with the DBS antenna.
Drill a hole through offset mast/offset mast assembly and swaged
tube. Secure the two together with #10 self tapping screw. NOTE:
Be sure to route coaxial cable through the slot provided at top of
offset mast when making coaxial connections.
Dish
Lag Bolts
Dish Mouting Bracket
Off-air Bracket
Non - Vertical Mounting
One Year Limited Warranty
Thomson Consumer Electronics will replace this antenna if
found to be defective in materials or workmanship. Return it
postage prepaid to the address below for prompt, no charge
replacement with a current equivalent antenna.
This replacement is TCE's sole obligation under this warranty.
TCE will not be responsible for any incidental or consequential
damages, or for any loss arising in connection with the use or
inability to use this product.
This warranty gives you specific legal rights, and you may also
have other rights which vary from State to State.
© 1998 Thomson Consumer Electronics, Inc.
Product Exchange Center, 32B Spur Drive
El Paso, Texas 79906
Offset Mast
#10 Self
Tapping Screw
U-Bolts
Swaged Tube
Mast Clamps
Nuts
Lockwashers
Advertisement
