SpeedLink RF CubePad User Manual page 13

Always recycle or dispose of used batteries in
accordance with local regulations.
If a battery leaks, remove all batteries and
thoroughly clean the battery compartment
with a damp paper towel, or follow the battery
manufacturer`s recommendations for clean-up.
5 Installation
1. Turn off your Game Cube.
2. Connect the receiver to the controller port 1
of your Game Cube.
3. If using only one controller, channel 1 must
be selected on your gamepad and your
receiver. If using more than one controller
please refer to chapter 5
6 Channel and band settings
Note: To guarantee a correct operation of your
controller, please make sure that if using only
one controller the band and channel settings are
selected as indicated in the table below.
D
GB
F
E
I
13