Troubleshooting - RCA 01A02 Owner's Manual

TROUBLESHOOTING

If you have a problem with the amplifier, first be sure all connections are correct and secure. If
the problem continues, check the following troubleshooting information for a solution.
Problem
No sound from
the speakers
No stereo sound
Distorted or
weak sound
Cannot record
This amplifier has been manufactured to the specifications of RadioShack and is covered by a
limited warranty from RadioShack. If your amplifier is not operating as it should, take it to
your local RadioShack store or call 1-800-THE-SHACK for assistance.
6
Headphones are connected to the amplifier. Unplug the headphones.
The source selector is set to the wrong audio source. Set the selector to
the correct source.
is set too low. Turn
VOLUME
If you connect a CD or tape player to the back panel and another to
the front panel, the back panel jacks are disabled. Disconnect the
player from the front panel jacks.
is pressed in. Press
MONO
is set all the way to one side. Adjust the control.
BALANCE
The speaker connections are incorrect. Turn off the amplifier and
correct the connections.
is set too high or too low.
VOLUME
The speaker connections are incorrect. Turn off the amplifier and
correct the connections.
The setting is incorrect. Set it to the correct position.
MAG/CER
is pressed in while you listen to a stereo source. Press
MONO
to the out position.
The connections between the tape deck and the amplifier's
jacks are incorrect or loose. Turn off the amplifier and
TAPE OUT
correct the connections.
The source selector is set to the wrong audio source. Set the selector to
the source you want to record.
If you connect a CD or tape player to the back panel and another to
the front panel, the back panel jacks are disabled. Disconnect the
player from the front panel jacks.
Solution
clockwise.
VOLUME
to the out position.
MONO
MONO
and
L R