Wff81 Fan Instructions - COZY W255G Installation And Operating Instructions Manual

NOTE:
This fan kit is to be installed after installation of wall furnace and with the wall furnace front panel in place.
STEP 1.
This appliance, when installed,
must be electrically grounded in
accordance with local codes, or in
the absence of local codes, with the
latest edition of the National Electric
Code, ANSI/NFPA No. 70. In
Canada, see the current Canadian
Electrical Code CSA C22.1.
STEP 2.
Set fan kit on top of the wall furnace
front panel. Using the back top edge
of the fan kit cabinet as a guide,
mark a horizontal line across the
wall. Mark a small vertical line which
aligns with the slot located toward
the rear of the fan kit casing.
STEP 3.
Using the four one inch screws
provided, secure the wall mounting
bracket to wall 1/8" below the horizontal
line. Fan attachment bracket must be
up and threaded nut sert aligned
with the small vertical line.
Note: Anchors (not provided) may be required.
STEP 4.
Remove junction box and connect 115v power supply in accordance with the wiring diagram. Replace junction box.
STEP 5.
Set fan kit on top of wall furnace front panel. Slot should align with the nut sert. Secure fan kit to wall mounting
bracket with thumb screw provided.
Fig. P
WHITE
L2
White
MODEL WFF81-C OPTIONAL FAN KIT - INSTALLATION INSTRUCTIONS
WFF81 - C
BLACK
MOTOR
115 VAC 60 HZ - Less than 12 Amps. If any of the original wire
as supplied with this appliance must be replaced, it must be replaced with
type thermoplastic 105 degree C wire or its equivalent.
Fig. O
Wall Mounting Bracket
Threaded Nut Sert
Fan
Attachment
Thumb Screw
Bracket
One
Inch
Screw (4)
Fan Kit
WIRING SCHEMATIC
L2 White
115 VAC
WHITE
BLACK
BLACK
GREEN GROUND WIRE
page 16
Slot
Wall Furnace
Front Panel
Ground
L1 Black
115 VAC
BLACK
FAN SWITCH
BLACK
Wiring
Diagram
Junction Box
L1
Black
84502-C