Table of Contents
Advertisement
Leveling Front-to-Back
1. Loosen the two bolts securing the mast to the mounting foot so the mast moves
freely.
2. Place a bubble level on the mast as shown in the figure. Move the mast so the
bubble is centered in the level's window.
Level
Rotate mast as
needed
3. Tighten the two bolts securing the mast to the mounting foot.
Final DIRECTV PLUS™ Dish Assembly
1. Attach the reflector to the support arm:
The top of the mast should slip on easily into the antenna clamp. Make sure that
the top of the mast has reached the pivot bolt running through the top of the
antenna clamp collar. The antenna should move from side to side easily once it is
on top of the support arm (Make sure that the mounting foot assembly is tightened
before setting the antenna on top).
Chapter 3
Not Level
Final Installation
Level
Not Level
Rotate mast as
needed
29
Advertisement
Table of Contents
