Table of Contents
Advertisement
Preparing for Installation
Setting the Elevation and Attaching the Fine
Tuning Adjustment
Use the elevation setting coordinate you wrote down on page 8 to preset the elevation
of the dish, and then attach the fine tuning adjustment tool.
1. Use a 1/4" x 1/2" carriage bolt, a washer, and a flange nut to attach the L-bracket
to the elevation slot.
2. Rotate the support sleeve so that the elevation indicator (white line), NOT the bolt
or the L-bracket, lines up with the tick mark on the mast corresponding to the
elevation setting you recorded earlier.
3. Tighten the flange nut securely and then secure a second 1/4" x 1/2" carriage bolt,
washer and flange nut on the opposite side.
4. Thread the bolt from the second L-bracket through the first L-bracket until the bracket
lines up with the hole on the mounting assembly. Double-check your elevation setting
and adjust if necessary.
5. Use a 1/4" x 1/2" carriage bolt, a flat washer, and a flange nut to attach the L-bracket
to the mast clamp.,
14
Use the white indicator, not the
nut or L-bracket to set the
elevation.
Fine Tuning Adjustment
Tool Hardware
Fine-Tuning Adjustment Bolt
L-Bracket
1/4" Flat Washer
1/4" Hex Flange Nut
1/4" x 1/2" Long Carriage Head Bolt
(Mast Adjusting Bolts)
Tip
To get the correct elevation, line
up the painted edge inside the
curved groove of the clamp with
the degree marker. Do NOT use
the bolt.
Chapter 1
Advertisement
Table of Contents
