Rci-2950 Specifications; Key Features - Ranger RCI-2950 Service Manual

Key Features

·Full Band Coverage - Covers the 10 Meter Amateur Band from 28.0000 to 29.6999 MHz.
·All Mode Operation - Operates on USB, LSB, CW, AM and FM.
·Brightness Control - Four Step LCD brightness control for easy viewing under any condition.
·Repeater Offset Switch - Gives you standard offsets for repeater operation.
·Programmable Frequencies - Allows you to program up to 10 individual frequencies. Includes battery backup.
·Built in Dual VFO - Choose steps of 10kHz, lkHz or 100Hz, manual or scan
·RIT - Receiver Incremental Tuning to fine tune the receive frequency up to +/- 3kHz.
·Squelch - Cuts off or eliminates receiver background noise in the absence of incoming signals.
·Noise Blanker - Greatly reduces repetitive impulse noise.
·RF Gain Control - Reduces the gain of the receiver under strong signal conditions to prevent overloading.
·RF Power Output Selector - Lets you select transmitting output power
·External Speaker Connection - Place a speaker anywhere for convenient listening.
·PA Mode - Use an external speaker for a mobile PA system.
·LCD Display - Large, easy to read backlit LCD display.
·Multi-Function LCD Meter - Indicates transmit power, receive signal strength, modulation, SWR Calibration and SWR.
Specifications
General
Transmitter
·Antenna Connector: UHF TYPE, 50 Ohm
·RF Transmit Modes: USB, LSB, CW, AM, FM
·RF Output Power: USB, LSB (25W); CW (8W); AM/FM (8W)
·Spurious Emissions: -50dB
·Carrier Suppression (SSB Modes): -50 dB
Receiver
·Sensitivity for 10dB SINAD: AM 0.5uV
·Sensitivity for 10dB SINAD: USB/LSB/CW 0.15uV
·Sensitivity for 12dB SINAD: FM 0.25uV
·Image Rejection Ratio: 65dB
·AGC Figure of Merit: SSB/CW/AM 80dB for 50mV for 10dB Change in Audio Output
·Audio Output Power: 2.5 Watts

RCI-2950 Specifications

·Frequency Range: 28.0000~29.6999 MHz
·Tuning Steps: 100Hz, 1kHz, 10kHz, 100kHz, 1MHz
·Emission Types: USB, LSB(A3J), CW(A1), AM(A3), FM(F3)
·Frequency Control: Phase-Locked Loop Synthesizer
·Frequency Tolerance: 0.005%
·Frequency Stability: 0.001%
·Operating Temperature Range: 0 to 40 degrees C.
·Antenna Impedance: 50 Ohms
·Microphone: 400 Ohms, Dynamic PTT
·Speaker: 8 Ohms, 2 Watts
·Display: Digital Frequency, LCD
·Meter Function: RF Output, Receive Signal Strength, Modulation, SWR Calibration, SWR
·Power Requirements: 13.8 Volt DC Negative Ground