PREPARATION
STAND INSTALLATION
PLASMA TV Models
I
Image shown may differ from your TV
I
When assembling the desk type stand, check whether the bolt is fully tightened. (If not tightened fully, thep
roduct can tilt forward after the product installation.) If you tighten the bolt with excessive force, the boltcan
deviate from abrasion of the tightening part of the bolt.
Carefully place the TV screen side
1
down on a cushioned surface to
protect the screen from damage.
Assemble the TV as shown.
2
Fix the 4 bolts securely using
3
the holes in the back of the TV.
Attaching the TV to a desk
The TV must be attached to desk so it cannot be pulled in a forward/backward direction, potentially causing
injury or damaging the product. Use only an attached screw.
1-Screw
(provided as parts of the product)
WARNING
!
To prevent TV from falling over, the TV should be securely attached to the floor/wall per installation
G G
instructions. Tipping, shaking, or rocking the machine may cause injury.
12
(Only 42PG1
, 42PG2
***
(Only 26/32/42LG1 *** , 26/32/42LG3 *** , 32/42LG5 *** )
, 32PC5
)
***
***
Only 32PC5 ***
Stand
Desk